SAPTEX Wall & Roofboards consist of a rigid closed cell polyurethane (PUR) or Polyisocyanurate (PIR) foam laminated with various types of facings.
SAPTEX Wall & Roofboards are manufac-tured in various thicknesses ranging frin 20 to 100 mm and densities from 32 to 50 kg/ m³. (Densities over 35 kg/m³ are produced on request).
SAPTEX Wall & Roofboards are produced on
a modern computerized – control plant, resulting in a very high quality product, which meets the requirements of national, Regional and International rigid, cellular thermal insulation standrad /specifications, these include:
SASO-GS0-BS 4841 ,BS-EN13165,ASTM-C1289.
SAPTEX Wall & Roofboards are laminated during the production process, foam auto-adhering with the required facing material, hence there is no risk of delamination as, in case, when adhesive is applied. A wide variety of facing materials are available. Different facings on either side of the board can be applied if required. Facing materials are Asphalt saturated felt paper, Glass fiber tissue with polyethylene film, Cellulose fiber glass, Aluminium foil backed with Kraft paper, and Aluminium foil backed by Glassmat.
2400 mm x 1200 mm and 1200 mm x 1200 mm.
Other sizes are available on request.
Wall & Roofboards are normally produced with straight edges, rebated edges are available at a little extra cost.
For large orders, SAPTEX offers products accustomed to client’s requements. (Independent research has proved that bigger board sizes have better thermal resistance values)
*Can be produced upon customer’s request
*The values given against the above properties are typical and are not meant to imply specification limit and should not be used for this purpose without reference to saptex
Always consult the local regulations and contact the manufacturer for technical ques-tions.
After installation the insulation boards must be protected against weather conditions and sunlight.
Properties shown are representative values for 1” thick material, unless otherwise specified.